Drift file not updating Sex chat site usa no registration

posted by | Leave a comment

The machine is a server machine which should run for very long. If you have all servers in an include file /etc/init.d/ntp ntptimeset does not work.

It has a watchdog which performs a hard reboot (using IPMI interface) in case some software is not running (it might be discussable if that's good but at the moment it's not possible to change that). Ok, so that explains why NTPD_FORCE_SYNC_HWCLOCK_ON_STARTUP="yes" does not work for me. But apparently the kernel only adjusts the hardware clock only if it is less than a maximum amount of time off, see here f.e.: What is the largest hardware clock update the Linux kernel "11-minute mode" can make?

This is recommended because virtual machines have no physical clock and can be paused at anytime and started back up hours later.

For further information see: https:// For further information about the # Welcome to the chrony configuration file.

Note that authenticated time synchronisation with Windows 2000 clients is not supported. server 127.127.1.0 fudge 127.127.1.0 stratum 10 # Where to retrieve the time from server 0iburst prefer server 1iburst prefer server 2iburst prefer driftfile /var/lib/ntp/ntp.drift logfile /var/log/ntp ntpsigndsocket /usr/local/samba/var/lib/ntp_signd/ # Access control # Default restriction: Allow clients only to query the time restrict default kod nomodify notrap nopeer mssntp # No restrictions for "localhost" restrict 127.0.0.1 # Enable the time sources to only provide time to this host restrict 0mask 255.255.255.255 nomodify notrap nopeer noquery restrict 1mask 255.255.255.255 nomodify notrap nopeer noquery restrict 2mask 255.255.255.255 nomodify notrap nopeer noquery .

Before deciding which time server software to install, You can see a comparison of ntp and chrony here https://chrony.tuxfamily.org/For example, the NTP modes table. This tells NTP not to panic and exit, no matter what the time offset is.

Any ideas what I can change to let the hardware clock be set by ntp? Uli In fact, the hardware clock is never set by NTP (that is, not directly). What output do you get, when you call "/etc/init.d/ntp ntptimeset" manually? Does it work when you call "hwclock -w --debug", i.e. In my case the server in /etc/are not reachable and therefore /etc/init.d/ntp ntptimeset has no effect.

drift file not updating-33drift file not updating-82drift file not updating-39

Alternatively you could configure all machines to do standard ntp, but NT5DS is recommended.The default maximum allowed time deviation in an AD is 5 minutes.If a domain member or domain controller (DC) has a higher or lower time difference, the access is denied.In an Active Directory (AD) you must have an accurate time synchronisation.For example, Kerberos requires correct time stamps to prevent replay attacks and the AD uses the time to resolve replication conflicts.

Leave a Reply

lesbiandating